Workman GTX Electric Lithium
Page 3B -- 4
Electrical System
After working on the vehicle electrical system, attach
battery conductors as follows (Fig. 2):
1. Make sure that key is removed from the key switch.
2. If installed, remove the rubber hose on the positive
(+) cable. Install the positive (+) cable onto the positive
terminal on the left, rear battery. Secure conductors to
battery with flange nut and torque tighten the nut from 72
to 88 in--lb (8 to 10 N--m); refer to Fig. 4.
3. If installed, remove the rubber hose on the negative
(--) cable. Install the negative (--) cable onto the negative
terminal on the right, front battery. Secure conductors to
battery with flange nut and torque tighten the nut from 72
to 88 in--lb (8 to 10 N--m); refer to Fig. 3.
4. Apply battery terminal protector (see Special Tools in
this chapter) to the connections after the conductors
have been secured to the battery terminals. Also, make
sure that boot is positioned over positive (+) and (--) ter-
minals.
5. Lower and secure cargo bed.
Figure 4
1. 1.27 mm (0.5 in) ID rubber hose
2. Positive (+) battery terminal
3. Flange nut
12
3
72 to 88 in--lb
(8 to 10 N--m)
To Next Page
Loading...
