TOS SUA 125 NUMERIC - Page 76

SUA 125 NUMERIC
34200003 TOS a.s. 02/2011
76
Recommended kinds and concentration of cutting coolants used on machine tools
TOS a.s. a.s. as manufacturer of machines recommends for user of this machine to use some if bellow
mentioned cutting coolant. These liquids dont influence perceptible on the surface of painting film as
well as on its adherence of the coating composition used on this machine.
The influence on surface coating was tested at concentrations introduced in table.
Designation:
Concentration:()
Manufacturer (supplier):
TRIGILUX
4,5
TRIGA s.r.o., Praha ČR
BLASER BLASOCUT 2000 UNI
5
KAT s.r.o., Brno ČR
CURTIS LUBRICANTZ
2,8
CLENTUS Praha ČR
CLENCUO II
4
CLENTUS Praha ČR
ALFEX 21
5
TRIGA s.r.o., Praha ČR
ALBEGOL B
5
TRIGA s.r.o., Praha ČR
EMULKAT H
5
TRIGA s.r.o., Praha ČR
EMULKAT UNI 100
5
TRIGA s.r.o., Praha ČR
CASTROL SYNTILLO R HS
5
CASTROL
PARAMUL EOPS
5
PARAMO a.s. Pardubice ČR
PARASOL SK 200
5
PARAMO a.s. Pardubice ČR
PARAMUL ERO SB
5
PARAMO a.s. Pardubice ČR
PARAMOL ERO D
5
PARAMO a.s. Pardubice ČR
The application of other cutting coolant has to be consulted with machine manufacturer.
In case of nonobserving above mentioned recommendations the user is exposed to a risk of coating
damage and to a disavowal of event. claim.
Parameter
Unit
Value
Standard
LK - 46
Kinematic viscosity at 40 °C
Mm2/s
46
ČSN EN ISO 3104