Chapter
5:
Setting
up
your
TV
Viewing
the
digital
signal
meter
You can view the digital signal meter
in
the
ANT/CABLE
digital
TV
input source only.
To
view the digital signal meter:
1 Press
MOU
and open the
Setup
menu.
2 Highlight Installation and press
8.
3 A new set
of
Installation menu icons will appear, as
shown below. Open the
Terrestrial
menu, highlight
Signal
Meter,
and press
8.
4 Press
..........
~
to select the antenna input and digital
channel whose signal you want to check.
Note:
•
The
physical digital channel number listed
in
the
Signal Meter screen may not correspond
to
a virtual
TV
channel number Contact your local broadcasters
to obtain the RF channel numbers for your local digital
stations
•
The
signal strength does not change between virtual
channels on the same physical channel
To
close the screen
and
return
to the Terrestrial
menu:
Highlight
Done
and press
8.
To
return
to
normal
viewing:
Press
Ecr
Setting
the
time
zone
The
Time
Zone
setup will allow you to specify the correct
time
zone
for your region.
This
feature will allow the
TV
status information to show the correct time zone information
(IrE page 50).
To
set the time zone:
1 From the
Setup
menu. highlight
Installation
and press
8.
A new set
of
Installation menu icons will appear.
2 Open the
Time
Zone
menu, highlight
Time
Zone
Setup,
and press
8.
3 Press
..........
~
to select the region, highlight
Done,
and
then press
8.
After the time zone has been set, you will be asked to set the
current Daylight Saving
Time
status.
To
set the Daylight Saving Time status:
1 Press
....
or
~
to select
Yes
or
No,
highlight
Done,
and then
press
8.
Viewing
the
system
status
To
view the system status:
1 Press
MOU
and open the
Setup
menu.
2 Highlight
Installation
and press
8.
3 A new set
of
Installation menu icons
wi
II
appear, as
shown below. Open the
System
Status
menu, highlight
System
Information,
and press
8.
4 Press
....
~
to scroll through the menu bar to select the
Software
Version
and view the related information.
To
close the screen
and
return
to the Installation
menu:
Highlight
Done
and press
8.
To
return
to normal viewing:
Press
Ee!r
Reset
Factory
Defaults
To
reset all settings
and
channels to
their
factory
default values:
1 Press
MOU
and open the
Setup
menu.
2 Highlight
Installation
and press
8.
A new set
of
Installation menu icons will appear.
3 Open the
System
Status
menu, highlight
System
Information,
and press
8.
4 Press
....
~
to scroll through the menu bar to select
Factory
Defaults.
5 Enter your PIN code (or 0000 if no PIN code has been set).
6 Highlight
Yes
and press
8.
The
TV
will turn
off
automatically after a few seconds. After the
TV
turns off,
unplug the
TV
power cord and then plug
it
in
again to
complete the reset process.
To
cancel the reset:
Highlight
No
and press
8.
To Next Page
Loading...
