Switching
between
two
channels
using
Channel
Return
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1 Select the first channel you want to view.
2 Select a second channel using the Channel Number
buttons (and the dash
(@!) button
if
selecting a digital
channel).
3 Press
CHaTN
on the remote control. The previous channel
will display. Each time you press
CHSN,
the TV will switch
back and forth between the last two channels that were
tuned.
Note:
If
you press
CHaTN
from a non-antenna input, the
TV
will return
to
the last-viewed input.
Switching
between
two
channels
using
SurfLock™
The
SurfLock™
feature temporarily "memorizes" one channel
to the
CHaTN
button, so you can return to that channel quickly
from any other channel by pressing
CHaTN.
To
memorize a
channel to the
CHaTN
button:
1 Tune the TV to the channel you want to program into the
CHaTN
button.
2 Press and hold
CC\TN
for about 2 seconds until the message
"Memorized" appears on-screen. The channel has been
programmed to the
CHaTN
button.
3
You
can then change channels repeatedly, and when you
press
CHaTN,
the memorized channel will be tuned.
The TV will return to the memorized channel one time only.
Once you press
CHaTN
and then change channels again, the CH
RTN
memory will be cleared and the button will function as
Channel Return, by switching back and forth between the
last two channels that are tuned.This feature also works for
external inputs.
Selecting
the
picture
size
You
can view many program formats in a variety
of
picture
sizes-Natural,
TheaterWide
1,
TheaterWide
2,
TheaterWide
3,
Full,
4:3
HD,
Native
and
Dot
by
Dot
(available
in
PC Mode
Only).
Note:
The
"picture size" illustrations are examples only
The
format
of
the image (in any
of
the picture sizes) will vary
depending on the format
of
the signal you are currently
watching. Select the picture size that displays the current
program the way that looks best
to
you.
You
can save separate picture size preferences for each input
on your
TV.
To
select the picture size using the remote control:
1 Press
P,cc3IZE
on the remote control.
2 While the
Picture
Size
screen
is
open, you can do one
of
the following to select the desired picture size:
• Repeatedly press
p,cc3IZE.
• Press the corresponding Number button
(0-6)
while the
Picture
Size
screen
is
open.
• Press
....
or ... while the
Picture
Size
screen
is
open.
To
select the picture size using the menus:
1 Select
Picture
Size
in
the
Theater
Settings
menu.
2
Press'"
or
~
to select the desired picture size setting.
3 Highlight
Done
and press
8.
Note: Some
of
the picture sizes
may
not be available
depending on the receiving signal format (those will
be
"grayed out"
in
the Picture Size screen).
Using these functions to change the picture size (i.e.,
changing the height! width ratio) for any purpose other than
your private viewing may be prohibited under the Copyright
Laws of the United States and other countries, and may
subject you to civil and criminal liability.
Note:
If
you select one
of
the TheaterWide® picture sizes, the
top
and
bottom edges
of
the picture (including subtitles
or
captions) may
be
hidden.
To
view the hidden edges, either
scroll the picture (TheaterWide
2
and
3 only)
or
try viewing
the program
in
Full
or
Natural picture size.
To Next Page
Loading...
