Toshiba 40RV52R - Adjusting Picture Settings

Chapter 6: Using the TV~ featufllS
Adjusting the picture
Adjusting the picture quality
Selecting the picture mode
You can adjust the picture quality (Contrast, Backlight,
DynaLight™, Brightness, Color, Tint, and Sharpness) to your
personal preferences.
You can select your desired picture settings from four different
modes, as described below.
Mode
Sports
Standard
Movie
PC
Picture Quality
Bright and dynamic picture (factory setting)
Standard picture settings (factory setting)
Lower contrast for darkened room (factory
setting)
Designed for viewing
of PC tables and
documents
Selection Pressing .... Pressing~
Contrast lower higher
Backlight* darker lighter
DynaLight** On/Off On/Off
Brightness darker lighter
Color
paler deeper
Tint
reddish greenish
Sharpness softer sharper
Note: PC mode is available for HOMI and PC inputs only
(grayed out for other input sources).
3 Press ... or ... to select the picture mode you prefer and
press@.
Picture Settings
Noise Reduction
Game Mode Off
Theater Settings
To adjust the picture quality:
" Backlight
This feature adjusts the brightness of the entire screen When
in
video mode and no signal is input, this will automatically be set to O.
(Settings are stored in memory.)
,.", DynaLight
This function automatically strengthens the black coloring of dark
areas
in the video according to the level of darkness.
1 Press MOU and open the Video menu.
2 Highlight Picture Settings and press @.
3 Press ... or ... to select the picture quality you want to
adjust
(Contrast, Backlight, DynaLight, Brightness, Color,
Tint, or Sharpness), and then press ~ or ~ to adjust the
setting, as described
in the table above.
4 To save the new settings, highlight Done and press @.
You can use any of the picture modes (1& "Selecting the
picture mode," above left) as a starting point for adjusting
the picture settings.
To revert back to the base mode that you began adjusting
the picture settings from, highlight
Reset and press @.
Your personal preferencesPreference
To select the picture mode using the menu system:
1 Press MOU and open the Video menu.
2 Highlight Mode and press @.
Standard
Movie
PC
Preference
The picture qualities you adjusted are automatically saved in
the Preference mode (1& "Selecting the picture Illode," above
left) until
Reset is selected.
Note: The picture mode you select affects the current
input only
You can select a different picture mode for
each input.