40"
TV
Choosing
a
location
for
your
LCD
TV
To
Display
your
LCD
TV
on
the
included
Pedestal
Stand:
Observe
the
following
safety
precautions:
I) Read and Follow the pedestal assembly instructions included
with the pedestal.
CAUTION:
Before beginning pedestal assembly, carefully lay the
front
of
the LCD Panel face down on a flat, cushioned surface
such
as
a quilt or blanker. Leave the bottom of the unit protruding
over the edge of the surface and assemble the pedestal
as
indicated below.
Note: Extreme care should always
be
used when attaching
the pedestal stand
to
avoid damage
to
the LCD panel.
2) Place the TV on a sturdy, level surface that can support the
weight
of
the
TV.
3) Be sure to secure the TV to a wall, pillar, surface,
or
other
immovable structure.
(BE
item 23, page 3).
Four
screws
VESA Mounting Pattern
Hook
Sturdy strap
(as short as possible)
Hook
Sturdy strap
(as
short
as
possible)
I
I I
VESA Mounting Pattern
Four
screws
46"
TV
M6
M8
StreW
Size
'
46" 400x200 mm
40" 200x200 mm
To
Display
your
LCD
TV
using
a
Wall
Bracket:
If
you
decide
to
wall
mount
your
LCD
TV,
always
use
a
UL
listed
wall
bracket
appropriate
for
the
size
and
weight
of
the
LCD
TV
(BE
page
2):
I)
CAUTION:
Two people are required for installation.
2)
Unplug and remove any cables and/or other component
connectors from the rear
of
the
TV.
3) Remove the screws
of
the VESA Mounting Pattern show
in
the right diagram.
4)
Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate bracket(s) are
attached to the wall and the back
of
the
TV
as described
in
the
instructions provided with the wall bracket.
5)
After attaching the appropriate bracket(s) to the wall and the
back
of
the TV, remove the pedestal stand from the
TV
as
described below.
6)
VESA Mounting Pattern
TV
Size
Hole
Pattern(HxV)
(unit in mm)
Removing
the
Pedestal
Stand
I) Carefully lay the front
of
the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the stand
protruding over the edge
of
the surface.
Note: Extreme care should always
be
used when removing
the pedestal stand to avoid damage to the LCD panel.
2) Remove the four screws shown
in
the right diagram. This will
allow removal
of
the pedestal stand.
3) Once you have removed all four screws holding the pedestal
stand
in
place, remove the pedestal stand from the
TV.
CAUTION:
Always
place
the
TV
on
the
floor
or
a
sturdy,
level,
stable
surface
that
can
support
the
weight
of
the
unit.
To
secure
the
TV,
use
a
sturdy
strap
from
the
hook(s)
on
the
rear
of
the
TV
to
a
wall
stud,
pillar,
or
other
immovable
structure.
Make
sure
the
strap
is
tight,
secure,
and
parallel
to
the
floor.
5
To Next Page
Loading...
Need help?
General
