Channel
tuning
problems
• Make sure the remote control
is
set to the correct device
mode
(irE
page 20).
•
The
channel may have been erased from the channel
memory
by the
Channel
AddlDelete
feature. Add the
channel to the channel
memory
(1& page 29).
•
The
channel may be blocked by the
Channels
Block
feature. Unblock the channel (1& page 46).
• If you are unable to tune digital channels, check the
antenna configuration
(1Gr'
page 28). If you are still
unable to tune digital channels,
clear
all
channels
from
the channel list
(lJSf'
page 30) and reprogram
channels
into the channel
memory
(1Qf
page 29). If you are still
unable to tune digital channels, use the Reset Factory
Defaults procedure
(1l2-~
page
32). Also see
"TV
stops
responding to
controls"
and
"Other
problems"
(IG\'
page 53).
Closed
caption
problems
• If the program
or
video you selected
is
not closed-
captioned, no captions
wi
II
display
(1Qf
page 41).
• If text
is
not available, a black rectangle may appear. If
this happens, turn
off
the closed caption feature
(Ir~Y
page 41).
• A closed-caption sigmll may not display correctly
in
the following situations: a) when a videotape has been
dubbed: b) when the signal reception
is
weak:
or
c) when
the signal reception
is
nonstandard
(1l$Y
page 41).
Rating
blocking
(V-Chip)
problems
• If you forget
your
PIN code: While the PIN
code
entering screen
is
displayed, press
REOLL
four
times
within 5 seconds.
The
PIN code you previously stored
will be cleared
(v::;y
page 44).
No
REGZA-L1NK
operation
•
The
REGZA-L1NK feature
is
available for Toshiba
REGZA-L1NK
compatible
devices.
•
Make
sure the HDMI cables with the HDMI
Logo
(HLlml)
are used.
•
When
the connected REGZA-L1NK device
does
not
work correctly after you have
changed
settings
of
the
device, turn
off
your
TV
and unplug the
power
cord.
then plug and turn on again.
•
If
several devices are connected, REGZA-L1NK feature
may not operate properly.
• Read the instruction manual furnished with the
connected REGZA-L1NK device.
HOMI
problems
For HOMI cables
• Make sure to use cables with the HDMI Logo
(HLlmIJ
(lQIo
page 15).
For Legacy HOMI source
•
Some
legacy HDMI sources may not work properly
with the latest HDM I
TV
products,
due
to new standard
adoption.
To Next Page
Loading...
