CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-129
nnn --- nnn: Data string to be printed (Omissible)
Max. 2000 digits
oo
1
--- oo
20
: Link field No. (Omissible)
01 to 99 (1 to 99 can also be used.)
Up to 20 digits can be designated using commas.
* The maximum of 2000 digits of data string to be printed and the maximum of 52 dots of the 1-cell
width are acceptable. (The maximum number of digits of the data string to be printed differs
depending on the error correction level and the contents of data.) However, note the following limits:
• The maximum of 2000-digit data string to be printed are acceptable. However, it cannot actually be
printed, since it cannot be contained within the head width.
• If the print ratio of one line (the print head width) is high, printing may become poor, or the printer
may be reset. Be careful about the print ratio.
• When a large value is set for the 1-cell width, decrease the number of digits of data to contain the
data within the head width.
To Next Page
Loading...
