Toshiba B-EP2DL-GH40-QM-R - 5.8.2 FEED COMMAND

CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-167
5.8.2 FEED COMMAND [ESC] T
Function Feeds the paper.
Format [ESC] Tabcde [LF] [NUL]
Term a: Type of sensor
0: No sensor
1: Reflective sensor
2: Transmissive sensor
3: Transmissive sensor (when using manual threshold value)
4: Reflective sensor (when using manual threshold value)
* In the case of the compatible mode for the B-SP series,
Reserved when 3 is specified. (If specified, it is processed as “2.”)
Reserved when 4 is specified. (If specified, it is processed as “1.”)
b: Reserved area
0 to 1
c: Reserved area
C, D, E
d: Reserved area
1 to 9, A
e: Reserved area
0 to 2
Explanation
(1) Type of sensor
c No sensor:
Feeding takes place according to the parameter designated by the Label Size Set
Command.
d Reflective sensor:
Feeding takes place according to the parameter designated by the Label Size Set
Command. However, the black mark provided on the back side of the tag paper is
automatically sensed by the reflective sensor and the stop position is finely adjusted.
e Transmissive sensor:
Feeding takes place according to the parameter designated by the Label Size Set
Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the stop position is finely adjusted.
(2) When any value other than the above is specified in the reserved area, an error occurs.
(When the above value is specified, this command is ignored.)