Toshiba B-EP2DL-GH40-QM-R - 8.6 VALUE SPECIFIED BY EACH COMMAND

CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-4
8.6 VALUE SPECIFIED BY EACH COMMAND
The values specified by each command are commonly applied in standard and page modes.
However, as for the following commands, values must be independently specified and maintained in
standard and page modes.
• [ESC] [SP] : Setting of spacing on the right of a character
• [ESC] 2 : Setting of 30-dot feeding
• [ESC] 3 : Setting of minimum dots for line feed
• [FS] S : Setting of spacing on both sides of a chinese character