CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-48
7.10.3 MODE INFORMATION ACQUIRE COMMAND [ESC] WX
Function Sends the printer mode information to the host.
Format [ESC] WX [LF] [NUL]
Explanation (1) The mode information format to be sent to the host, is as follows:
RECEIPT mode (Mode = 1)
[IrDA: TEC Protocol]
STX
Mode information (16 bytes)
CRC CRC
R E C E I P T SP SP SP SP SP SP SP SP SP
02H 52H 45H 43H 45H 49H 50H 54H 20H 20H 20H 20H 20H 20H 20H 20H 20H xxH xxH
[IrDA: IrCOMM, IrDA: IrOBEX, USB, RS-232C, Bluetooth, Wireless LAN]
STX
Mode information (16 bytes)
R E C E I P T SP SP SP SP SP SP SP SP SP
02H 52H 45H 43H 45H 49H 50H 54H 20H 20H 20H 20H 20H 20H 20H 20H 20H
RECEIPT1 mode (Mode = 2)
[IrDA: TEC Protocol]
STX
Mode information (16 bytes)
CRC CRC
R E C E I P T 1 SP SP SP SP SP SP SP SP
02H 52H 45H 43H 45H 49H 50H 54H 31H 20H 20H 20H 20H 20H 20H 20H 20H xxH xxH
[IrDA: IrCOMM, IrDA: IrOBEX, USB, RS-232C, Bluetooth, Wireless LAN]
STX
Mode information (16 bytes)
R E C E I P T 1 SP SP SP SP SP SP SP SP
02H 52H 45H 43H 45H 49H 50H 54H 31H 20H 20H 20H 20H 20H 20H 20H 20H
The above shows examples where the message is received in the RECEIPT mode
(Mode = 1) and the RECEIPT1 mode (Mode = 2). In addition, the messages described
on the following page are returned.
To Next Page
Loading...
Need help?
General