CHAPTER 3 INTERFACE
B-EP Series
3-6
[TPCL mode]
Data to be sent
STX
Printer ID
Status Remaining No. of labels CRC
02H xxH xxH 3xH 3xH 3xH 3xH 3xH 3xH 3xH xxH xxH
• Printer ID ......... 2-byte hex data (in order from High to Low)
• Status .............. Detailed status is indicated in 2-byte data.
“00”: Normal state
“01”: Cover open state
“02”: Operating
“04”: Pause state
“05”: Wait for strip
“06”: Command syntax error (including Ir packet error)
“09”: Normal issue end + Label end
“11”: Paper jam
“13”: Label end
“15”: Cover open error
“17”: Broken head dots error
“18”: Thermal head excessive temperature
“19”: Ambient temperature error
“32”: Abnormal battery temperature
“33”: Battery excessive temperature
“36”: Low battery
“37”: Charging error
(“38”: Bluetooth setting successfully completed) Response status for automatic status
transmission
“39”: Bluetooth setup error (including initialization error)
( “40”: Normal issue end) Response status for automatic status transmission
( “41”: Normal feed end) Response status for automatic status transmission
“45”: Wait for battery recovery
“46”: Wait for head temperature reduction
“47”: Wait for motor temperature reduction
“50”: Flash ROM write error
“51”: Flash ROM erase error
“54”: Flash ROM storage area full state
“55”: Writable character/PC command save mode
Range of CRC calculation
To Next Page
Loading...
