CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-16
Printer status ......... Printer status is indicated in 1-byte data.
00H: Normal status (Idling)
01H: Cover open status
02H: Command syntax error (including Ir packet error)
03H: Paper jam
04H: Label end
05H: Cover open error
06H: Broken thermal head dots error
07H: Thermal head excessive temperature
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH: Printer operating
0CH: Communication error
......... * For RECEIPT mode/RS-232C connection only
0DH: Normal end + Label end (See NOTE.)
0EH: Flash ROM storage area full state
0FH: Wait for strip ....... * Only in the LABEL mode
(10H: Normal issue end)
Response status for automatic status transmission
14H: Pause state
19H: Ambient temperature error
32H: Abnormal battery temperature
33H: Battery excessive temperature
37H: Charging error
38H: Bluetooth setting successfully completed
39H: Bluetooth setup error (including initialization error)
45H: Wait for battery recovery
46H: Wait for head temperature reduction
47H: Wait for motor temperature reduction
55H: Writable character/PC command save mode
NOTE: In the LABEL mode, “0DH: Normal end + Label end” is
a state when the printer runs out of labels, after the
effective print length is printed. In the RECEIPT mode,
this status is returned to the host when the printer runs
out of labels after a receipt is issued.
To Next Page
Loading...
Need help?
General