CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-19
Printer status
“00”: Normal state
“01”: Cover open state
“02”: Operating
“04”: Pause state
“05”: Wait for strip
“06”: Command syntax error (including Ir packet error)
“11”: Paper jam
“13”: Label end
“15”: Cover open error
“17”: Broken thermal head dots error
“18”: Thermal head excessive temperature
“19”: Ambient temperature error
“32”: Abnormal battery temperature
“33”: Battery excessive temperature
“36”: Low battery
“37”: Charging error
“38”: Bluetooth setting successfully completed
(Not returned when the Status Request Command is used)
“39”: Bluetooth setup error (including initialization error)
(“40”: Normal issue end)
Response status for automatic status transmission
(“41”: Normal feed end)
Response status for automatic status transmission
“45”: Wait for battery recovery
“46”: Wait for print head temperature reduction
“47”: Wait for motor temperature reduction
“50”: Flash ROM write error
“51”: Flash ROM erase error
“54”: Flash ROM storage area full state
“55”: Writable character/PC command save mode
To Next Page
Loading...
