Why is my Toshiba Barcode Reader cutter not cutting?
If the cutter on your Toshiba Barcode Reader isn't cutting, make sure the Cutter Cover is properly attached. Also, check for any media jammed in the cutter and remove it. Clean the cutter blade if it is dirty.
How to troubleshoot a RIBBON ERROR on a Toshiba Barcode Reader?
If your Toshiba Barcode Reader displays a RIBBON ERROR, the ribbon may not be feeding properly, or it might not be loaded. Remove the ribbon and check its status, replacing it if necessary. If the problem persists, contact a TOSHIBA TEC authorized service representative. Ensure a ribbon is loaded, if it is missing. The ribbon sensor could also have a problem; in this case, contact a TOSHIBA TEC authorized service representative.
What does SYNTAX ERROR mean on my Toshiba B-EX4T2?
If your Toshiba Barcode Reader displays a SYNTAX ERROR, it means that while the printer was in Download mode for upgrading the firmware, it received an improper command. Turn the printer off, and then on again.
Why doesn't the cutter work on my Toshiba B-EX4T2?
If the cutter on your Toshiba Barcode Reader isn't cutting, ensure the Cutter Cover is properly attached. Also, check for and remove any media jammed in the Cutter. Finally, clean the cutter blade.
Why does the Strip Module on my Toshiba B-EX4T2 Barcode Reader not remove labels from the backing paper?
If the Strip Module on your Toshiba Barcode Reader isn't removing labels from the backing paper, it could be because the label stock is too thin or the glue is too sticky. Set the Pre Peel function to ON.
Why is the printed image blurred on my Toshiba Barcode Reader?
If the printed image from your Toshiba Barcode Reader is blurred, it might be due to an incorrect combination of ribbon and media; select an appropriate ribbon for the media type being used. Alternatively, the Print Head might be dirty; clean it using the Print Head Cleaner or a cotton swab slightly moistened with ethyl alcohol.
What does MEMORY FULL mean on Toshiba B-EX4T2?
If your Toshiba Barcode Reader displays 'MEMORY FULL', saving failed because of insufficient storage space in the flash ROM/USB memory. Turn the printer off, and then on again.
What does EEPROM ERROR mean on Toshiba B-EX4T2 Barcode Reader?
If your Toshiba Barcode Reader displays 'EEPROM ERROR', data cannot be properly read from or written to a backup EEPROM. Turn the printer off, and then on again.
What to do for EXCESS HEAD TEMP on Toshiba B-EX4T2 Barcode Reader?
If your Toshiba Barcode Reader shows EXCESS HEAD TEMP, the Print Head has overheated. Turn off the printer and let it cool down for about 3 minutes. If the problem persists, contact a TOSHIBA TEC authorized service representative.
Why won't my Toshiba Barcode Reader media feed?
If the media isn't feeding in your Toshiba Barcode Reader, ensure that the media is loaded properly. Also, check for any error messages on the display and resolve them.
General| Print Method | Thermal transfer |
|---|---|
| Resolution | 203 dpi |
| Print Width | 104 mm |
| Interfaces | USB |
| Optional Interfaces | Wireless LAN |
| Barcodes | Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, ITF, Codabar, MSI |
| 2D Codes | Data Matrix, PDF417, QR Code, Maxi Code |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 25 - 85% RH (Non-condensing) |
To Next Page
