Toshiba B-EX4T2 SERIES - Initial Setting Wizard

2.PRINTER SETUP
24
LANGUAGE E N G L ISH
▲
E N G L ISH
GE R MAN
F R E N C H
▼
Select E N T E R ： Set
PRINT MODE w/ R I BB O N
With R I BB O N
Without R I BB O N
▼
Select E N T ER ： Set
CALIBRATE OFF
OFF
L A BE L / G A P
BLACK MA R K
▼
Select E N T ER ： Set
2.6.9 Initial Setting Wizard
THE first time the printer is used after opening carton box or after a RAM clear, the initial setting wizard
will start when the power is switched on. This wizard enables setting basic parameters, such as the LCD
language and print mode. The values set with this wizard can be changed in the system mode and also by
command.
Example of the Initial Setting Wizard Operation
RAM clear with QM type
selected
1 ． Perform a RAM clear.
QM T Y P E
C LE A R ...
↓
QM T Y P E
C O M P LETE D
T u r n o ff t h e p r i n t e r
↓ Power OFF/ON
B - E X Se r ie s
I niti a li z in g .
..
↓
2 ． The initial setting wizard
starts.
STARTUP S E TT I N G S PRESS
E N T ER
↓ [ENTER] key
3 ． Select a language.
Choose the desired option
with the [UP] or [DOWN] key
and press ENTER to set.
↓ [ENTER] key
4 ． Print mode
▲
Choose the desired option
with the [UP] or [DOWN] key
and press ENTER to set.
↓ [ENTER] key
5 ． Select a calibration type.
▲
Choose the desired option
with the [UP] or [DOWN] key
and press ENTER to set.
6.-1 When an option other than “OFF” is selected for CALIBRATE