Toshiba B-EX4T2 SERIES Manual

2.PRINTER SETUP
20
2.6 OUTLINE OF EACH MODE
This chapter describes the outline of each mode supported by the printer. Refer to each chapter for detailed
information.
2.6.1 ONLINE MODE
This mode is mainly used by users (operators).
The label or tag can be issued in the online mode. When an error occurs, the help function shows the
cause of the error, troubleshooting, and recovery from the error. The threshold setting, described below,
is also a part of the online mode.
2.6.2 Threshold setting mode
Threshold setting mode is provided to correct a print failure with pre-printed media.
When using pre-print label, print start positions may not be detected correctly with the usual media sensor
threshold, depending on the ink type. Such error can be prevented by setting the threshold just for the pre-
printed media to be used. Since the threshold setting value is stored in the non-volatile memory, it is
unnecessary to set the threshold again as long as the same pre-print media is used.
2.6.3 Information mode
In the information mode, the total feed amount counted during feeding and printing operations is
displayed on the LCD in units of centimeter and inch.
Printing of the feed amount is performed on request.

Toshiba B-EX4T2 SERIES Specifications

General

Print Method	Thermal transfer
Resolution	203 dpi
Print Width	104 mm
Interfaces	USB
Optional Interfaces	Wireless LAN
Barcodes	Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, ITF, Codabar, MSI
2D Codes	Data Matrix, PDF417, QR Code, Maxi Code
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 60°C
Humidity	25 - 85% RH (Non-condensing)