Toshiba B-EX4T2 SERIES - Appendix 1 Messages and Leds

APPENDIX 1. MESSAGES AND LEDS
53
APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. : The LED is flashing. : The LED is unlit.
2: %%,%%%,%%%: Remaining memory size of the external memory: 0 to 09,999,999 (in K bytes)
3: ####: Remaining memory size for PC commands storage area in the internal memory: 0 to 3072 (in K bytes)
4: &&&&: Remaining memory size for writable characters storage area: 0 to 3147 (in K bytes)
No.
LCD Message
LED Indication
Printer Status
Restoration by
RESTART key
Acceptance of
Status Request/
Reset Command
ONLINE
ERROR
Yes/No
Yes/No
1
ON LINE


In online mode
-----
Yes
ON LINE


In online mode (The printer is
communicating)
-----
Yes
2
HEAD OPEN


The print head block is open in online
mode.
-----
Yes
3
PAUSE


The printer is paused.
Yes
Yes
4
COMMS ERROR


A parity, overrun, or framing error has
occurred during communication
through the RS-232C.
Yes
Yes
5
PAPER JAM


The media is jammed during paper
feed.
Yes
Yes
6
CUTTER ERROR


A problem has occurred with the cutter
module.
Yes
Yes
7
NO PAPER


The media has run out, or the media is
not loaded properly.
Yes
Yes
8
NO RIBBON


The ribbon has run out.
Yes
Yes
9
HEAD OPEN


Feed or printing was attempted with
the print head block open.
Yes
Yes
10
HEAD ERROR


There is a problem with the print head.
Yes
Yes
11
EXCESS HEAD TEMP


The print head has overheated.
No
Yes
12
RIBBON ERROR


The ribbon has been torn. A problem
has occurred with the sensor that
determines the torque for the ribbon
motor.
Yes
Yes
13
REWIND FULL


An overflow error has occurred in the
rewind unit.
Yes
Yes
14
SAVING####KB/&&&&KB
or
SAVING%,%%%.%%%KB


Writable character or PC command
save mode
-----
Yes
15
FORMAT####KB/&&&&KB
or
FORMAT%,%%%.%%%KB


The storage area is being initialised.
-----
Yes
16
NOW LOADING…


TrueType font or BASIC program is
being downloaded.
-----
Yes
17
MEMORY WRITE ERR.


An error has occurred while writing to
flash memory or USB memory.
No
Yes
18
FORMAT ERROR


An erase error has occurred while
formatting the flash memory or USB
memory.
No
Yes
19
MEMORY FULL


Data cannot be stored because the flash
memory or USB memory is full.
No
Yes
20
SYNTAX ERROR
(Refer to “Notes”)


A command error has occurred while
analyzing the command.
Yes
Yes
21
POWER FAILURE


A power failure has occurred.
No
No