Toshiba B-EX4T2 SERIES - Page 59

APPENDIX 1. MESSAGES AND LEDS
54
No.
LCD Message
LED Indication
Printer Status
Restoration by
RESTART key
Acceptance of
Status Request/
Reset Command
ONLINE
ERROR
Yes/No
Yes/No
22
EEPROM ERROR


Data cannot be read from/written to a
backup EEPROM properly
No
No
23
SYSTEM ERROR


When the following abnormal
operations are performed, a system
error occurs:
(a) Command fetch from an incorrect
address.
(b) Access to word data at an
incorrect address.
(c) Access to long-word data at an
incorrect address.
(d) Access to the area of 80000000H
to FFFFFFFFH in the logic space
in user mode.
(e) An undefined instruction in an
area other than a delay slot was
decoded.
(f) An undefined instruction in a
delay slot was decoded.
(g) An instruction to rewrite a delay
slot was decoded.
No
No
24
DHCP CLIENT INIT…


DHCP Client is being initialised. (Only
when the DHCP is enabled.)
-----
-----
25
RFID WRITE ERROR


The printer did not succeed in writing
data onto an RFID tag after having
retried the specified number of times.
Yes
Yes
26
RFID ERROR


The printer cannot communicate with
the RFID module.
No
Yes
27
INPUT PASSWORD


The printer is waiting for a
password to be entered.
No
No
28
PASSWORD INVALID


A wrong password was entered
three consecutive times.
No
No
29
RFID CONFIG ERROR


B-EX700-RFID-U2-EU/US-R,
B-EX700-RFID-U4-EU/US-R, U4
Module preinstall model only RFID
Module’s destination code is not
specified.
No
No
30
LOW BATTERY
( Refer to Notes)


RTC Battery is low.
No
Yes
31
INTERNAL COM ERR


A hardware error has occurred in the
internal serial interface.
No
No
NOTE: When an error message listed above appears on the LCD display please refer to Section 5
TROUBLESHOOTING for a solution.