e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-72
(2) Enter the adjustment mode [05]. Adjust each setting value for the custom mode to satisfy the user’s request.
• Select the necessary adjustments from the procedures below.
To match the density level of background scanned with the original glass equivalent to that
of background scanned with the RADF
(a) Enter the adjustment mode [05]. Change the value for the code [7025] to adjust the reproducibility of
the background of the image scanned with the RADF. The larger the setting value is, the darker the
background becomes. The smaller the setting value is, the lighter the background becomes.
[05] code Recommended value
Acceptable
range
value
Default
05-7025
Set a value smaller than 128 to
make the background darker.
Set a value larger than 128 to make
the background lighter.
0 to 255 128
To copy while eliminating the background color (to adjust the reference value for the
background density adjustment)
* This adjustment is effective when you do not copy the dark color of the background of an original.
(a) Enter the adjustment mode [05]. Change the values for codes [7236] and [7237] to make the range
correction operation fixed.
• The code to be set differs depending on the density mode. Select the [05] code for the target
original mode and change the value to “0”.
Original
mode
Density mode [05] code
Recommended
value
Acceptable
range value
Default
Automatic 05-7236
Text/Photo
Manual 05-7237
0 0, 1 1
* Explanation for setting values
Setting
value
Range correction
operation
0 Fixed
1 Varied
2. Copier-specific Adjustments
To Next Page
Loading...
Need help?
General
