1 PREPARATION
20 Preparation 2 - Loading Paper
5
Load paper face up in the drawer.
y Up to 250 sheets (80 g/m
2
or 20 lb. Bond) can be loaded. Be sure that the height of the stacked paper does
not exceed the line indicated inside of the side guides.
P.17 “Acceptable paper types”
y Fan the paper well before loading it in the drawer, otherwise multiple feeding could occur. Be careful not to
cut your fingers.
y The printable side may be noted on its packaging.
6
Move the end guide to the trailing edge of the paper while pushing its lower part in the
direction of the arrows.
Widen the gap with both hands.
7
Push the drawer straight into the equipment slowly until it stops.
Do not catch your fingers in the drawer when closing it.
This could cause injury.
Register the paper size into the equipment.
When you load paper in the drawer for the first time, register the paper size. Be sure to register it correctly,
otherwise it could cause a paper misfeed.
For the registration, see the following pages:
P.26 “Preparation 3 - Registering Paper Size and Type”
Be sure to register the paper size each time you have changed it.
To Next Page
Loading...
