1 PREPARATION
24 Preparation 2 - Loading Paper
1
Place an envelope on a flat clean surface and press it with your hands in the arrow
directions as shown below to expel air from the inside.
Press it well to prevent the flap from rolling upward.
Correct bent corners of the envelope.
2
Open the bypass tray.
3
Pull the paper holding lever out, and then load the envelope face down on the bypass
tray.
Place the envelope with its flap side at the front as shown below.
Do not copy or print on the back of envelopes, otherwise it may cause a paper misfeed or soil them or the inside
of the equipment.
To Next Page
Loading...
