3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 41
[A] Installation of the high-voltage transformer jig
The high-voltage transformer jig is composed of 2 cables and 1 adapter with a harness.
Attach them to the process unit as shown in the figure.
* Black cable (thick line): Use the screw for the jig. (M3 x 8)
* Red cable (thick line): Use the screw for the process unit.
* Adapter: Use the screw for the process unit.
Note:
The adjustment may damage the drum. Therefore be sure to replace the drum with the one that
you brought (or the one for measurement) before starting the adjustment.
Fig. 3-20
(1) Open the automatic duplexing unit.
(2) Open the front cover and take off the toner
cartridge.
(3) Loosen 2 screws and pull out the process
unit.
Fig. 3-21
Change the drum
Screw
Black cable (thick line)
Harness
Screw
Screw
Adapter
Red cable (thick line)
Disconnect 1 connector
Process unit
To Next Page
Loading...
