e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 30
Is the registration sensor working?
(Perform the input check in the test mode: 03-[FAX]ON/[9]/[A]
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the registration sensor is disconnected.
2. Check if the connector CN316 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the registration sensor.
6. Replace the LGC board.
YES
Is the bypass feed clutch/ADU clutch working?
(Perform the output check in the test mode: 03-204/222)
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the bypass feed clutch/ADU clutch is
disconnected.
2. Check if the connector CN311 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the bypass feed clutch/ADU clutch.
6. Replace the LGC board.
YES
Check the registration roller. Replace it if it is worn out.
[E320] Paper fed from the PFP upper drawer not reaching the 2nd transport sensor
[E350] Paper fed from the PFP lower drawer not reaching the 2nd transport sensor
[E3E0] Paper fed from the LCF not reaching the 2nd transport sensor
Open the side cover. Is there paper in front of the 2nd transport sensor?
YES Remove the paper.
NO
Is the 2nd transport sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[7]/[A]
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the 2nd transport sensor is disconnected.
2. Check if the connector CN316 on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the 2nd transport sensor.
6. Replace the LGC board.
YES
To Next Page
Loading...
