e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 30
[B] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment and turn the power
OFF using the main power switch.
(3) Remove 1 screw and take off the finisher board access cover.
Fig. 8-25
(4) Release the latches and take off the rear lower cover of the hole punch unit.
Fig. 8-26
Board access cover
Rear lower cover
To Next Page
Loading...
