8
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
8 - 31
(5) Remove 3 screws and take off the rear cover of the hole punch unit.
Fig. 8-27
(6) Connect the download jig with the jig connector (CN9) on the finisher control PC board.
Fig. 8-28
(7) Set the DIP-SW4 on the hole punch control PC board to ON.
Fig. 8-29
(8) Turn the power ON using the main power switch while simultaneously holding down the [0] and
[8] buttons.
Updating starts and the LED on the download jig lights.
Rear cover
Download jig
ON
1234
To Next Page
Loading...
