Toshiba e-STUDIO355 - Page 61

2
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
SELF-DIAGNOSIS MODES
2 - 33
280 Process Forced performing of
idling for toner recycle
ALL - M Perform this adjustment
before the replacement
of the developer material.
(The toner is forcibly
removed from the
cleaner.)
6
286 Laser Laser power
adjustment
ALL e-STUDIO205L/
255/305:
65
e-STUDIO355/
455:
121
<0-255>
M When the value
increases, the laser
output increases
correspondingly.
3
305 Scanner Image location
adjustment of
secondary scanning
direction
(scanner section)
ALL 124
<90-166>
SYS When the value
increases by “1”, the
image shifts by approx.
0.13013 mm toward the
trailing edge of the paper.
1
306 Scanner Image location
adjustment of primary
scanning direction
(scanner section)
ALL 113
<0-255>
SYS When the value
increases by “1”, the
image shifts by approx.
0.0846 mm toward the
front side of the paper.
1
308 Scanner Distortion mode ALL - - Moves carriages to the
adjusting position.
(Ch.3.3.4)
6
340 Scanner Reproduction ratio
adjustment of
secondary scanning
direction
(scanner section)
ALL 128
<63-193>
SYS When the value
increases by “1”, the
reproduction ratio in the
secondary scanning
direction (vertical to
paper feeding direction)
increases by approx.
0.05 mm.
1
350 Scanner Shading
position
adjustment
Original
glass
ALL 117
<92-165>
SYS 0.13013 mm/step 1
351 RADF ALL 133
<92-165>
SYS 1
354 RADF Adjustment
of RADF
paper
alignment
for
single -
sided
original
ALL 10
<0-20>
SYS When the value
increases by “1”, the
aligning amount
increases by approx.
0.5 mm.
1
355 for
double
sided
original
ALL 10
<0-20>
SYS 1
357 RADF Fine adjustment of
RADF transport speed
ALL 50
<0-100>
SYS When the value
increases by “1”, the
reproduction ratio of the
secondary scanning
direction when using the
RADF increases by
approx. 0.1%.
1
358 RADF RADF sideways
deviation adjustment
ALL 128
<0-255>
SYS When the value
increases by “1”, the
image of original fed from
the RADF shifts toward
the rear side of paper by
approx. 0.08423 mm.
1
Adjustment mode (05)
Code
Classific
ation
Items
Funct
ion
Default
<Acceptable
value>
Boa
rd
Contents
Proce
dure