e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
2 - 34
359 Scanner Carriage position
adjustment during
scanning from RADF
(black)
ALL 128
<0-255>
SYS When the value
increases by “1”, the
carriage position shifts by
approx. 0.1 mm toward
the exit side when using
the RADF.
1
360 Scanner Carriage position
adjustment during
scanning from RADF
(color)
ALL 128
<0-255>
SYS 1
361 Scanner Log table switching for
RADF copying
ALL
(color
)
0
<0-4>
SYS 0: Same log table as the
one used at copying
with original glass
1: Background
reproduction - Light 2
2: Background
reproduction - Light 1
3: Background
reproduction - Dark 1
4: Background
reproduction - Dark 2
1
362 Scanner Log table switching for
RADF copying
ALL
(black
)
0
<0-4>
SYS 0: Same log table as the
one used at copying
with original glass
1: Background
reproduction - Light 2
2: Background
reproduction - Light 1
3: Background
reproduction - Dark 1
4: Background
reproduction - Dark 2
1
363 Scanner Data transfer of
characteristic value of
scanner / SYS board
→ SLG board
SCN - SYS Transfers the
characteristic values of
the scanner (shading
correction factor / RGB
color correction /
reproduction ratio color
aberration correction /
shading position
correction factor /
reproduction ratio
correction value in
primary scanning
direction) from the SRAM
of the SYS board to the
SRAM of the SLG board.
6
364 Scanner Data transfer of
characteristic value of
scanner / SLG board
→ SYS board
SCN - SYS Transfers the
characteristic values of
the scanner (shading
correction factor / RGB
color correction /
reproduction ratio color
aberration correction /
shading position
correction factor /
reproduction ratio
correction value in
primary scanning
direction) from the SRAM
of the SLG board to the
SRAM of the SYS board.
6
Adjustment mode (05)
Code
Classific
ation
Items
Funct
ion
Default
<Acceptable
value>
Boa
rd
Contents
Proce
dure
To Next Page
Loading...
