e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 30
3.5.2 Sharpness adjustment
If you want to make scan images look softer or sharper, perform the following adjustment.
< Adjustment Mode (05) >
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0,1 or 2), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [ENTER] or [INTERRUPT] button to store the value in memory. The equipment goes
back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Shut down (turn the power OFF), back ON, and then perform the scanning job.
(8) If the desired image density has not been attained, repeat step (1) to (7).
Original mode
Item to be
adjusted
Remarks
Text/Photo Photo Text Gray Scale
865-0 867-0 866-0 868-0 150 to 200 dpi Key in the following values
depending on the original mode.
One’s place
Leave the value in one’s place at
the fixed value.
Ten’s place
1 to 9: Change intensity
• The larger the value is, the
sharper the image becomes.)
• Example of value entry in
case the mode is “Text/
Photo”.
865-1 867-1 866-1 868-1 300 to 400 dpi
865-2 867-2 866-2 – 600 dpi
21
Fixed value for Text/
Photo mode
Key in a value 1 to 9
To Next Page
Loading...
