e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 56
3.11 Adjustment of the RADF
3.11.1 Adjustment of RADF position
It is mainly performed at the installation. It is also required when the RADF is dislocated for some rea-
son such as moving the equipment.
Remove the platen sheet during adjustment.
<Procedure>
(1) Open the RADF and remove the positioning
pin hole covers.
Fig. 3-52
(2) Attach 2 positioning pins to the equipment.
Fig. 3-53
Positioning pin
To Next Page
Loading...
