To Next Page

To Previous Page

ADJUSTMENT

3 - 83

(7) The mode LED1~4 light OFF and the writing operation of the tray width adjustment data into the

EEPROM is finished.

* When the writing into the EEPROM has been finished, make sure to check the result with the

following table.

3.15.2 Input check 1

This is a mode at which the checking of each motor, solenoid and clutch operation is carried out.

(1) Turn ON the power with pressing the control panel mode key and start key. (The start LED blinks

in green.)

(2) Press the mode key and set up the LED1 to blink and LED2~4 to light OFF, and press the start

key. (The start LED lights ON in green.)

* With pressing the mode key for more than 1 sec., all the mode LEDs light OFF and become

able to be reset.

(3) Press the mode key and check the operations referring to the following table. The operational

mode is switched at every time the mode key is pressed.

* Num (at the right table): the number of times which the key is pressed

* At the operational mode 7~36, the motor rotation speed is switched whenever the start key is

pressed. The motor rotation speed can be checked by referring to the mode LED blinking

speed.

Mode LED blinking at 1000msec. cycle: Low speed

Mode LED blinking at 700msec. cycle: Medium speed

Mode LED blinking at 500msec. cycle: High speed 1

Mode LED blinking at 250msec. cycle: High speed 2

Mode LED blinking at 100msec. cycle: High speed 3

Writing result

Mode LED display

LED1 LED2 LED3 LED4

Success - -

Failure (minimum position) - -

Failure (maximum position) - -

Failure (both maximum ) and minimum

positions)

: Blinking

:Light ON

- : Light OFF

Toshiba E-STUDIO520 Service Handbook

Other manuals for Toshiba E-STUDIO520