© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO520/523/600/603/720/723/850/853
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 9
2
2.1.2 Service call
Error code Classification Contents Troubleshooting
C130 Paper feeding sys-
tem related ser-
vice call
1st drawer tray abnormality: The tray-up motor-1 does
not run normally or the 1st drawer tray does not move
normally.
(Feeding of any other drawer than the 1st drawer is pos-
sible.)
Ch.5.1.6
C140 2nd drawer tray abnormality: The tray-up motor-1 does
not run normally or the 2nd drawer tray does not move
normally.
(Feeding of any other drawer than the 2nd drawer is pos-
sible.)
Ch.5.1.6
C150 3rd drawer tray abnormality: The tray-up motor-2 does
not run normally or the 3rd drawer tray does not move
normally.
(Feeding of any other drawer than the 3rd drawer is pos-
sible.)
Ch.5.1.6
C160 4th drawer tray abnormality: The tray-up motor-2 does
not run normally or the 4th drawer tray does not move
normally.
(Feeding of any other drawer than the 4th drawer is pos-
sible.)
Ch.5.1.6
C180 Tandem LCF tray-up motor abnormality: The Tandem
LCF tray-up motor does not run normally or the Tandem
LCF tray does not move normally.
(Feeding of any other drawer than the Tandem LCF is
possible.)
Ch.5.1.6
C1A0 Tandem LCF end fence motor abnormality: The Tandem
LCF end fence motor does not run normally or the Tan-
dem LCF end fence does not move normally.
(Feeding of any other drawer than the Tandem LCF is
possible.)
Ch.5.1.6
C1C0 Option LCF tray-up motor abnormality: The Option LCF
tray-up motor does not run normally or the Option LCF
tray does not move normally.
(Feeding of any other drawer than the Option LCF is pos-
sible.)
Ch.5.1.6
C260 Scanning system
related service call
Peak detection error: Lighting of the exposure lamp
(white reference) is not detected when the power is
turned ON.
Ch.5.1.7
C270 Carriage home position sensor not turning OFF within a
specified period of time: The carriages do not shift from
their home position within a specified period of time.
Ch.5.1.7
C280 Carriage home position sensor not turning ON within a
specified period of time: The carriages do not reach their
home position within a specified period of time.
Ch.5.1.7
C360 Process related
service call
Wire cleaner drive motor abnormality: The wire cleaner
drive motor does not run normally or the charger wire
cleaner does not move normally.
Ch.5.1.13
C370 Transfer belt cam motor abnormality: The transfer belt
cam motor does not run normally when the power is
turned ON or the copying is started.
Ch.5.1.13
To Next Page
Loading...
