Toshiba E-STUDIO520 - Setting of Fuser;Pressure Roller Temperature

To Next Page

To Previous Page

ADJUSTMENT

3 - 52

3.10.2 Setting of fuser/pressure roller temperature

The fuser has been set (heat roller surface temperature: 200°C) taking the fusing performance, wrin-

kling, curling and toner transfer deficiency at the leading/trailing edges of the duplex print into consider-

ation when our company recommended paper is used. This is to allow the characteristics of the paper

to be demonstrated in a well-balanced manner. However, various types of paper are used in the field,

and factors such as the paper thickness and smoothness greatly effect the fusing performance, in par-

ticular. If the fusing performance deteriorates while using a specific type of paper, deal with that by

changing the fuser roller temperature at the setting mode "08".

Change the fuser roller temperature (in ready status, during printing).

To improve fusing efficiency, a change is made in the range of the setting value between "12" and "14"

(200°C to 210°C).

Notes:

1. When a large value is set (to increase the temperature), the level of wrinkling, curling and

toner transfer deficiency at the leading/trailing edges of the duplex print tends to be wors-

ened.

2. Do not set the fuser roller temperature in the ready status (08-411) higher than the one during

printing (08-410, 413, 437, 412).

3. When printing with OHP, remember that the OHP films tend to stick together if the setting

value for the fuser roller temperature (08-1804) is higher than the default value.

Change the starting temperature of the pressure roller low speed pre-running during ready in the setting

mode (08-845, 847). To improve the fusing quality, change the setting value to "12" (110°C).

Note: Note:

The frequency of pre-running is increased when the starting temperature of the pressure roller

pre-runningduring ready is increased.

Code Contents

411 Fuser roller temperature in ready status

410 Fuser roller temperature during printing with plain paper

413 Fuser roller temperature during printing with thick paper 1

437 Fuser roller temperature during printing with thick paper 2

412 Fuser roller temperature during printing with thick paper 3

1804 Fuser roller temperature during printing with OHP

05/04

Other manuals for Toshiba E-STUDIO520