Toshiba E-STUDIO520 - Scan Motor

e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 44
3.7.3 Scan motor
When the scan motor has been installed again, adjust the belt tension in the following procedure.
<Procedure>
(1) Install the belt tension jig (spring).
(2) Loosen 2 screws. Then tighten these screws when the belt is tensed enough.
Fig. 3-38
Screw
Scan motor
Belt tension jig
Screw