© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO520/523/600/603/720/723/850/853
ADJUSTMENT
3 - 31
3
3.5.3 Setting range correction
The values of the background peak / text peak in the range correction can be switched to “varied” or
“fixed” in the following codes.
If they are fixed, the range correction is performed with standard values.
The values of the background peak affect the reproduction of the background density and the values of
the text peak affect that of the text density.
< Adjustment Mode (05) >
<Procedure>
Procedure is same as that of P.3-29 "3.5.1 Density adjustment".
3.5.4 Setting range correction (Adjustment of background peak)
The levels of the background peak for the range correction can be set at the following codes.
< Adjustment Mode (05) >
<Procedure>
Procedure is same as that of P.3-29 "3.5.1 Density adjustment".
Original mode
Item to be
adjusted
Remarks
Text/Photo Photo Text Gray Scale
825 827 826 828 Range correction
for original manu-
ally set on the origi-
nal glass
The following are the default val-
ues set for each original mode.
Text/Photo: 12, Photo: 12, Text:
12, Gray Scale:12
Each digit stands for:
One’s place: Automatic density
mode
Ten’s place: Manual density
mode
The setting conditions possible
are as follows:
Background peak Text peak
1: fixed fixed
2: varied fixed
3: fixed varied
4: varied varied
830 832 831 833 Range correction
for original set on
the RADF
Original mode
Item to be
adjusted
Remarks
Text/Photo Photo Text Gray Scale
835 837 836 838 Background peak
for range correc-
tion
When the value increases, the
background (low density area) of
the image is not output.
Acceptable values: 0 to 255
(Default: text/photo: 40, photo:
16, text: 48, Gray Scale:16)
To Next Page
Loading...
Need help?
General
