Toshiba E-STUDIO520 - Stitching Position (Adjusting Center Stitching)

e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 78
(9) Change the settings of bits 6 through 8 on DIPSW1 referring to the table below.
• If the width adjustment is "0",
The stitching position and the folding position match, requiring no change.
• If for "positive width adjustment," Set DIPSW1 so that the difference resulting from subtraction
of the interval from the appropriate setting in the table is provided.
For instance, if the DIPSW1 is currently set to +2 and the interval is +1 mm, set DIPSW1 to
reflect -2.
• If for "negative width adjustment" Set DIPSW1 so that the sum resulting from addition of the
interval from the appropriate setting is provided.
For instance, if the DIPSW1 is currently set to -1 and the interval is +0.5 mm, set DIPSW1 to
reflect +1.
Do not touch the following:
(10) Set bits 1 through 4 on DIPSW1 to OFF.
3.13.2 Stitching Position (adjusting center stitching)
Use the host machine adjustment mode to perform the following:
DIPSW1 bit settings
Settings
(in units of 0.5 mm)
bit 6 bit 7 bit 8
OFF ON ON +3
OFF ON OFF +2
OFF OFF ON +1
OFF OFF OFF 0
ON OFF ON -1
ON ON OFF -2
ON ON ON -3
bit 6 bit 7 bit 8
ON OFF OFF