e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 8
EAE0 Finisher jam Receiving period time-out jam: The printing cannot
be finished normally due to the communication
error between the equipment and the Finisher when
the paper is transported from the equipment to the
Finisher.
Ch.5.1.5 [ 5 ]
EB30 Ready period time-out jam: The equipment judges
that the paper transport to the Finisher is disabled
due to the communication error between the equip-
ment and the Finisher at the start of the printing.
Ch.5.1.5 [ 5 ]
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of the preceding paper caused the misfeed-
ing of the upcoming paper.
Ch.5.1.1
EB60 Paper remaining on the transport path: The multiple
feeding of the preceding paper caused the misfeed-
ing of the upcoming paper (= redetection after no
jam is detected at [EB50]).
Ch.5.1.1
EC00 Finisher jam
(Inserter section)
Inserter feeding delay jam Ch.5.1.5 [ 4 ]
EC10 Inserter feeding stop jam Ch.5.1.5 [ 4 ]
EC20 Inserter reverse path delay jam-1 Ch.5.1.5 [ 4 ]
EC30 Inserter reverse path stop jam-1 Ch.5.1.5 [ 4 ]
EC40 Inserter reverse path delay jam-2 Ch.5.1.5 [ 4 ]
EC50 Inserter reverse path stop jam-2 Ch.5.1.5 [ 4 ]
EC60 Inserter transport delay jam-1 Ch.5.1.5 [ 4 ]
EC70 Inserter transport stop jam-1 Ch.5.1.5 [ 4 ]
EC80 Inserter transport delay jam-2 Ch.5.1.5 [ 4 ]
EC90 Inserter transport stop jam-2 Ch.5.1.5 [ 4 ]
ECA0 Paper remaining in Inserter Unit at power-ON Ch.5.1.5 [ 4 ]
ECB0 Incorrect setting of paper size for Inserter Unit Ch.5.1.5 [ 4 ]
ECC0 Inserter Unit misfeeding Ch.5.1.5 [ 4 ]
ECD0 Inserter Unit door open jam Ch.5.1.5 [ 4 ]
Error code Classification Contents Troubleshooting
To Next Page
Loading...
