Toshiba E-STUDIO5506AC - Page 101

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-55
2. Copier-specific Adjustments
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7960], [7961], [7965], [7966],
[7970], [7971], [7975], [7976] and [7980] to [7983] to adjust the density for each color.
Color to
adjust
Original mode [05] code Subcode
Recommended
value
Accep
table
value
range
Default
Y
(Yellow)
Text/Photo
05-7960
0/1/2
Set a value larger than
128.
0 to
255
128
Text
05-7961
0/1/2
User custom
05-7980
0/1/2
Red seal color
05-7984
0/1/2
M
(Magenta)
Text/Photo
05-7965
0/1/2
Text
05-7966
0/1/2
User custom
05-7981
0/1/2
Red seal color
05-7985
0/1/2
C
(Cyan)
Text/Photo
05-7970
0/1/2
Text
05-7971
0/1/2
User custom
05-7982
0/1/2
Red seal color
05-7986
0/1/2
K
(Black)
Text/Photo
05-7975
0/1/2
Text
05-7976
0/1/2
User custom
05-7983
0/1/2
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted.
Subcode
Area where the density is adjusted
0
Low-density area
1
Medium-density area
2
High-density area

Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.