e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-115
3. Printer-specific Adjustments
* It is enabled only in the Twin color copy mode.
Select [05 ADJUSTMENT MODE]. Change the setting value of code [8108].
Color mode [05]code Subcode Recommended value
<Note> • When the setting value of this code is changed to “0”, the sharpness adjustment on the
Windows menu is also changed to OFF automatically.
• When the setting value of this code is larger than "128" (default), the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "0" to "+4" on the printer
driver menu. When the setting value of this code is smaller than "128", the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "-4" to "-1" on the
printer driver menu. Note that when the setting value of this code is "0", the image quality will
not be changed even if the value is changed on the printer driver menu.
3.24.3To Print a Full-Color Original in Two Colors
To adjust the boundary between black and colors other than black
(1) Select [05 ADJUSTMENT MODE]. Change the values for codes [8213 to 8215] to adjust the boundary
between black and colors other than black.
* As the set value is increased, the area of "CHANGE BLACK TO" will become larger. On the other hand, if
the value is decreased, the area of "SECOND COLOR" will become larger.
Apply to [05] code Recommended value
To Next Page
Loading...
Need help?
General
