Toshiba E-STUDIO5506AC - When Adjusting the Image Quality of the Full Color Mode

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-85
2. Copier-specific Adjustments
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7150] to [7152] to
adjust the noise reduction level.
Color mode
Original
mode
[05] Code Recommended value
Acceptable
value range
Default
Black
Text/Photo
7151
Set a value smaller than
100.
0 to 200 100
Text
7152
User custom
7150
* The smaller the value is, the larger the noise reduction level becomes. The larger the value is, the smaller
the noise reduction level becomes.
* When "0" is set for the setting value, this function becomes disabled.
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular
2.23.2 When adjusting the image quality of the Full color mode
* Both the service technician and the user can use all steps of this adjustment.
<Notes>
・This adjustment is available when the Text/Photo mode is selected for the original mode for full color copying.
・Normally, the use with the factory default setting (Disabled) is recommended since the adjustment may
decrease the reproducibility of fine characters.
(1) Press [Image] and then [ADF Noise Reduction] on the control panel.
Change the setting value of the noise reduction level.
Setting value
Description
None
The noise reduction function is disabled.
Low
The noise reduction level is low.
Middle
The noise reduction level is medium.
High
The noise reduction level is high.
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular