Toshiba E-STUDIO5506AC - Creating or installing clone files

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 28
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
1.6 To Adjust Printing Positions on Front and Back Sides in the
duplex mode

Explanation
The printing positions on the front and back sides of business cards may deviate. The amount of this deviation
can be reduced with image position or image distortion adjustment.

Procedures
* The service technicians must perform all adjustments in accordance with the procedures below.
(1) Overview of adjustment
Image position adjustment: Adjust values as closely as you can to the target value (+/-0).
(To make printing positions as precise as possible)
(2) Image position adjustment
Refer to the “6.1.7 Image dimensional adjustment at the printing section” of the Service Manual and adjust
the image positions by approximating values from [A] to [F] below to a target value (+/-0) as closely as
possible.
Items Chart
Adjustment
Tolerance
Chart
Adjustment
Tolerance
[A] Reproduction ratio of the primary
scanning direction
05-98* 200 ± 0.5 mm 05-315 4.2 ± 0.5 mm
[B] Primary scanning data writing start
position
05-98
52 ± 0.5 mm
05-315*
4.2 ± 0.5 mm
[C] Reproduction ratio of the secondary
scanning direction (Fine adjustment of
transfer belt motor rotation speed)
200 ± 0.5 mm 4.2 ± 0.5 mm
[D] Secondary scanning data writing start
position
52 ± 0.5 mm 4.2 ± 0.5 mm
[E] Primary scanning data writing start
position at duplexing
05-3
52 ± 0.5 mm
05-316*
4.2 ± 0.5 mm
[F] Secondary scanning data writing start
position at duplexing
52 ± 0.5 mm 4.2 ± 0.5 mm
* Use this chart to adjust the void width match.