e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 29
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Reproduction ratio adjustment of primary scanning direction
Adjust the reproduction ratio of primary scanning direction in printing.
05-4001 PRT/FAX
The larger the value is, the larger the reproduction ratio in the
primary scanning direction becomes. (0.1%/step)
Acceptable values: 0 to 255 (Default: 128)
Perform adjustments according to the following procedure while checking the chart output by [05
Adjustment Mode].
Notes:
• Since the reproduction ratio may vary due to expansion and contraction of paper immediately
after the image is printed out, it is recommended to measure its dimension after at least 3 minutes
have passed.
• Use the second drawer, A3/LD.
• Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
<Procedure>
(1) Select [05 ADJUSTMENT MODE].
(2) Key in a code and press the [START] button.
(3) Key in the adjustment value. (To correct a value, press [CLEAR].)
(4) Press [OK] to store the value. → The equipment goes back to the ready state.
(5) Check the chart.
If the image is not in the desired reproduction ratio, repeat steps (2) to (4).
To Next Page
Loading...
