Toshiba E-STUDIO5506AC - To Obtain Image in Even Density Level

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-81
2. Copier-specific Adjustments
2.21 To Obtain Image in Even Density Level
Original
After adjustment
Feeding
direction
When the density is adjusted automatically, the
density on the entire copy image becomes
uneven.
When the density is adjusted
manually, the density of the entire
copy image is even.
Before adjustment
Feeding
direction

Explanation
When an original with a background is copied in the automatic density adjustment mode, unevenness may occur
on the copied background. Perform this function to avoid density unevenness.

Procedures
* Both the service technicians and the users can use steps (1) and (3).
* Only the service technicians can use step (2).
(1) Press [BASIC] on the control panel and press [ ] to lower the copy density manually.
After the adjustment is complete, make a copy and confirm the image quality. If uneven image density still
persists, have the service technicians perform the following procedure.