Toshiba E-STUDIO5506AC - To Copy Sharply (to Enhance Sharpness)

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-43
2. Copier-specific Adjustments
2.9 To Copy Sharply (To enhance sharpness)
Before adjustment
After adjustment
The image looks light and blurred on the copy.
The edges are enhanced and the copy image
becomes sharper.

Explanation
Perform adjustment regarding image processing (sharpness intensity), in order to obtain a sharper copy image,
when a light or blurred original is copied.

Procedures
* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more than
required or loses the effectiveness of the adjustment, restore the settings made in the previously used procedure
to the original ones. Then use other procedures.
* Both the service technician and the user can use procedures (1) and (2).
* Only the service technician must use procedure (3).
(1) Press [IMAGE] on the Control Panel. Press [ONE TOUCH ADJUSTMENT].
Press [CLEAR] .
After selecting the “Clear” option, copy and check the copy image quality.
When the copy image quality with the “Clear” option selected is insufficient, cancel the “Clear” option and
use the next procedure.
(The one-touch adjustment can be canceled by pressing [ONE TOUCH ADJUSTMENT] again.)
(2) Press [IMAGE] on the Control Panel. Press [SHARPNESS].
Press [SHARP] to increase the sharpness intensity.
After increasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.