Toshiba E-STUDIO5506AC - To Adjust the Tint of Specified Colors for Twin-Color or Single-Color Copying

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-71
2. Copier-specific Adjustments
2.16.3 To Adjust the Tint of Specified Colors for Twin-Color or Single-Color
Copying

Explanation
In twin-color or single-color copying, the tint of the color specified from the control panel can be changed by
adjusting the toner amount of the color (Y, M, C or K).

Procedures
*The service technician must perform all adjustments.
(1) Select [05 ADJUSTMENT MODE]. Change the values of codes [7644] to [7653] to adjust the value of Y, M,
C or K for the tint of the specified color.
(2) After changing the setting value, reboot the equipment, and check the tint of the image printed in twin-color
or single-color copying.
* Select the subcode (0 to 3) depending on which toner color (Y, M, C and K) you want to change.
* When the subcode for the specified color (Y, M, C or K) is larger, the toner amount for the adjusted color
increases, when the former is smaller, the latter decreases.
* If the value is too large, the density becomes too dark and the reproducibility of gradations in the high-
density area may become blurred and degraded. Therefore, carefully perform the adjustment, while
checking the copy or print image.
* When all the subcodes are set to “0”, the specified color becomes white.
* Adjustments for yellow green, pink, orange and purple are enabled in mono color copying only.
Specified color
from the control
panel
Color of toner
amount to be
adjusted
[05] code Subcode
Acceptable
value range
Default
Magenta
Y
7644
0
0 to 255 128
M
1
C
2
K
3
Yellow
Y
7645
0
0 to 255 128
M
1
C
2
K
3
Yellow green
Y
7646
0
0 to 255 128
M
1
C
2
K
3
Cyan
Y
7647
0
0 to 255 128
M
1
C
2
K
3
Pink
Y
7648
0
0 to 255 128
M
1