Toshiba E-STUDIO5506AC - Confirm or change the SNMP settings

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-58
2. Copier-specific Adjustments
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.
* For further information regarding the adjustment procedures, refer to procedure (3) in 2.2 To Closely Match
the Color Balance of the Original.
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must use the next procedure.
(4) Select [05 ADJUSTMENT MODE]. Change the values for codes [7960] to [7979] and [7980] to [7987] to
adjust the density level of each color.
Color to
adjust
Original mode
[05] code
Subcode Recommended value
Acceptable
value range
Default
Y
(Yellow)
Text/Photo
05-7960
0/1/2
Set a value larger than 128
to increase the density.
Set a value smaller than
128 to decrease the
density.
0 to 255 128
Text
05-7961
0/1/2
Printed image
05-7962
0/1/2
Photo
05-7963
0/1/2
Map
05-7964
0/1/2
User custom
05-7980
0/1/2
Red seal color
05-7984
0/1/2
M
(Magenta)
Text/Photo
05-7965
0/1/2
Text
05-7966
0/1/2
Printed image
05-7967
0/1/2
Photo
05-7968
0/1/2
Map
05-7969
0/1/2
User custom
05-7981
0/1/2
Red seal color
05-7985
0/1/2
C
(Cyan)
Text/Photo
05-7970
0/1/2
Text
05-7971
0/1/2
Printed image
05-7972
0/1/2
Photo
05-7973
0/1/2
Map
05-7974
0/1/2
User custom
05-7982
0/1/2
Red seal color
05-7986
0/1/2
K
(Black)
Text/Photo
05-7975
0/1/2
Text
05-7976
0/1/2
Printed image
05-7977
0/1/2
Photo
05-7978
0/1/2
Map
05-7979
0/1/2
User custom
05-7983
0/1/2
Red seal color
05-7987
0/1/2
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set the
subcode for the area to be adjusted.
Subcode
Area where the density is adjusted
0
Low-density area
1
Medium-density area
2
High-density area