Toshiba E-STUDIO5506AC - Page 160

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-24
3. Printer-specific Adjustments
(2) Select [05 ADJUSTMENT MODE]. Change the values for codes [8210] to [8212] and [8249] to [8254]
to adjust the judgmental threshold for the “Pure Black and Gray” setting.
PDL
Original
mode
[05] code Subcode
Recommended
value
Acceptable
value range
Default
PS
Text
8252
0/1/2/3/4
The larger the value,
the wider the area to
be replaced with that
for printing with only
black toner becomes.
The smaller the value,
the smaller the area to
be replaced with that
for printing with only
black toner becomes.
1 to 255
8/8/8/8/8
Graphics
8253
0/1/2/3/4
1 to 255
1/1/1/8/1
Image
8254
0/1/2/3/4
1 to 255
1/1/1/8/1
PCL
Text
8210
0/1/2/3
1 to 255
8/8/8/8
Graphics
8211
0/1/2/3
1 to 255
1/1/1/8
Image
8212
0/1/2/3
1 to 255
1/1/1/8
XPS
Text
8249
0/1/2/3/4
1 to 255
8/8/8/8/8
Graphics
8250
0/1/2/3/4
1 to 255
1/1/1/8/1
Image
8251
0/1/2/3/4
1 to 255
1/1/1/8/1
Subcode
Image Quality Type
0
General
1
Photograph
2
Presentation
3
Line Art
4
Advanced
* If the default value is “1”, change the “Pure Black and Gray” setting to “Off” on the Color Settings menu
of printer driver since no value smaller than 1 is provided.
When “Text, Graphic & Image” is selected for the “Apply to” setting on the printer driver setting menu,
photo areas whose colors are close to black may be treated as black because the larger the value is, the
wider the area to be printed only with K toner becomes. Therefore adjust the value carefully while
checking the copied image.