Toshiba E-STUDIO5506AC - Page 174

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-38
3. Printer-specific Adjustments
(2) Select [05 ADJUSTMENT MODE]. Increase the setting values for codes [8108] to [8113] and [8118] to
adjust the sharpness to be increased.
・Adjust the [05] code for the settings (color mode and original type) to be used for printing.
Color
mode
Image quality type [05] code
Subcode
Recommended
value
Acceptable
value
range
Default
Auto/Color
General
05-8110
0/1/2
Set a value larger
than 128.
0 to 255 128
Photo
05-8111
0/1/2
Presentation
05-8112
0/1/2
Line art
05-8113
0/1/2
Mono color
－
05-8118
0/1/2
Twin color
－
05-8108
0/1/2
Auto/Color
Red seal color
05-8109
0/1/2
Subcode
Original
0
Text
1
Graphic
2
Image
<Note> • When the setting value of this code is larger than "128" (default), the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "0" to "+4" on the printer
driver menu. When the setting value of this code is smaller than "128", the level of the sharpness
intensity is equivalent to the one when the value is set within a range of "-4" to "-1" on the
printer driver menu. Note that when the setting value of this code is "0", the image quality will
not be changed even if the value is changed on the printer driver menu.

Caution after the adjustment
The adjustment may possibly cause rough edges of the image contained in low-resolution bitmap data. As a
result, outlined edges may look shaded, black bands may appear, and toner may be scattered around the lines.
Therefore, carefully perform the adjustment, while checking the printouts.