e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-44
3. Printer-specific Adjustments
Procedures
* Both the service technicians and the users can perform step (1).
* Only the service technicians can perform step (2).
(1) Change the setting of the sharpness in the printer driver.
For Windows
Open the property page of the printer driver. Click [Setting] in the “Image Quality” tab.
Uncheck the “Use Sharpness Filter” checkbox in the “Image Attribute” tab. To make a smoother image,
check its checkbox and then set the value within a range of “-1” to “-4.”
• Setting “-4” provides the smoothest (softest) print image.
The value “OFF” of sharpness intensity adjustment is positioned as shown below.
* Sharpness adjustment is not available when 1200 dpi is selected for PS3 printer driver.
To Next Page
Loading...
