Toshiba E-STUDIO5506AC - Page 203

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-67
3. Printer-specific Adjustments
After changing the option on the printer driver, print and check the print image quality.
If further image quality adjustments are still necessary, use the next procedure.
* This adjustment will have an effect only on Black and white mode printing.
(5) Select [05 ADJUSTMENT MODE]. Increase the values for codes [7315 to 7320] or [7309 to 7310] to adjust
the gamma curve balance and increase the density on Black and White mode printing.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Halftone [05] code Subcode
Recommende
d value
Acceptable
value range
Default
PS3
(600dpi)
Smooth
05-7315
0/1/2
Set a value larger
than 128
0 to 255 128
Detail
05-7316
0/1/2
Auto (Text)
05-7360
0/1/2
Auto (Graphic)
05-7361
0/1/2
Auto (Image)
05-7362
0/1/2
PS3
(1200dpi)
Smooth
05-7309
0/1/2
Detail
05-7310
0/1/2
PCL6
Smooth
05-7317
0/1/2
Detail
05-7318
0/1/2
Auto (Text)
05-7363
0/1/2
Auto (Graphic)
05-7364
0/1/2
Auto (Image)
05-7365
0/1/2
XPS
Smooth
05-7319
0/1/2
Detail
05-7320
0/1/2
Auto (Text)
05-7366
0/1/2
Auto (Graphic)
05-7367
0/1/2
Auto (Image)
05-7368
0/1/2
* Set the value in increments of approximately 10, while checking the printouts until the optimum value is
obtained.
PCL6
PS3
Mac
XPS